H-1020 Semi-Automatic Stretch Wrap Machine

H-1020 Semi-Automatic Stretch Wrap Machine


ULINE’s H-1020 Semi-Automatic Stretch Wrap Machine is
perfect for small to medium-sized operations looking for a quick and efficient way to
secure loads. With a capacity of 4,000 pounds and speed of 12 RPMs, the H-1020 securely wraps up to 20 loads per hour,
increasing productivity while eliminating operator strain and fatigue. Your Semi-Automatic Stretch Wrap Machine arrives fully assembled and ready
for set-up. After uncrating the unit, transport to the desired location by
placing forks through the pockets at the rear base of
the machine. Place the machine close to an area where you will be wrapping your pallet
loads, making sure there is sufficient room to load/unload the machine and the
floor is able to bear the weight of the machine, load and equipment. A standard 120 VAC, 15-amp outlet will be needed to provide
power for the unit. To finish setup, power on the unit and
release the emergency stop switch. Adjust Turntable and Carriage Speeds to desired settings for the amount of stretch wrap you need
for your load. Press the System Reset then Start buttons to return the
turntable and the carriage to their home positions. To adjust how high
the carriage can wrap, loosen the knob for the height limiter and move upward or downward. To load the film, loosen the upper arm of the Film
Carriage. Place the film on the lower core holder, lock the upper arm back down and tighten.
With the Stretch Handle in the off position, pull off about five feet of film. Thread it through the black rollers following the threading diagram and turn
the stretch handle back on. Now pull the film and attach to the
load on the pallet. Once your film is ready to go, set the film tension to the desired
level between 0 and 100, depending on the weight, size and shape of your skid. Now you can
select your wrap mode. The Wrapping Mode button provides the
option of having the pallet wrapped in both the upward and downward position for
added strength or just the upward direction. Once you have selected your wrap model, choose the number of top and bottom wraps and press Start to begin wrapping. To
reinforce the wrap on the pallet, press and hold the Banding
button. This will keep the film carriage in place until released. The photo sensor will read when the
stretch wrap carriage has reached the top of the load. If you need to add more wrap to the top
of the load, lower the photo sensor. If you need to
reduce the amount being applied at the top of the load, raise the photo sensor. To manually control
the machine, use the Carriage and Turntable Jog
buttons. Press the Carriage jog button once to jog up and then hit Start. Press
again to jog down, and a third time to hold its position.
Once the film carriage is at the desired height, press the turntable jog button to begin
wrapping. When the machine stops or you’ve added
additional reinforcement where needed, tear the stretch wrap, wipe down the
trailing edge. You’re ready to wrap the next pallet. The
optional H-1071 Ramp is ideal for use with manual pallet trucks and jacks, allowing closer access to the turntable.
The H-1020 comes with a 2-year warranty on parts and is made in the USA. You can rely on ULINE for all your shipping needs.

About the author

Leave a Reply

Your email address will not be published. Required fields are marked *